Evaluating The Performance Of Topobathymetric Lidar To Support Multi-Dimensional Flow Modelling In A Gravel-Bed Mountain Stream

Stream biophysical processes are commonly studied using multi-dimensional numerical modelling that quantifies flow hydraulics from which parameters such as habitat suitability, stream carrying capacity, and bed mobility are derived. These analyses would benefit from accurate high-resolution stream bathymetries spanning tens of kilometres of channel, especially in small streams or where navigation is difficult. Traditional ground-based survey methods are limited by survey time, dense vegetation and stream access, and are usually only feasible for short reaches. Conversely, airborne topobathymetric LiDAR surveys may overcome these limitations, although limited research is available on how errors in LiDAR-derived digital elevation models (DEMs) might propagate through flow models. This study investigated the performance of LiDAR-derived topobathymetry in support of multi-dimensional flow modelling and ecohydraulics calculations in two gravel-bedded reaches (approximately 200 m long), one morphologically complex and one morphologically simple, and at the segment scale (32 km-long stream segment) along a 15 m-wide river in central Idaho, USA. We compared metre and sub-metre-resolution DEMs generated from RTK-GPS ground and Experimental Advanced Airborne Research LiDAR-B (EAARL-B) surveys and water depths, velocities, shear stresses, habitat suitability, and bed mobility modelled with two-dimensional (2D) hydraulic models supported by LiDAR and ground-surveyed DEMs. Residual statistics, bias (B), and standard deviation (SD) of the residuals between depth and velocity predicted from the model supported by LiDAR and ground-survey topobathymetries were up to -0.04 (B) and 0.09 m (SD) for depth and -0.09 (B) and 0.20 m s(-1)(SD) for velocity. The accuracy (B = 0.05 m), precision (SD = 0.09 m), and point density (1 point m(-2)) of the LiDAR topobathymetric survey (regardless of reach complexity) were sufficient to support 2D hydrodynamic modelling and derivative stream habitat and process analyses, because these statistics were comparable to those of model calibration with B = 0 m and SD = 0.04 m for water surface elevation and B = 0.05 m s(-1)and SD = 0.22 m s(-1)for velocity in our investigation. (c) 2020 John Wiley & Sons, Ltd.