Post-Treatment of the Effluent from Anaerobic Digestion of the Leachate in Two-Stage SBR System Using Alternative Carbon Sources

Although anaerobic digestion (AD) enables biogas production and facilitates renewable electricity production, its effluent must be post-treated before discarding it into the environment. However, during AD designing, the post-treatment step is often overlooked. This paper presents the kinetics and efficiency of nitrogen removal from effluent after AD of leachate from the aerobic stabilization of the organic fraction of municipal solid waste. A two-stage SBR system was used. An ammonium oxidation rate of 15.5 mg N-NH4/(L center dot h) ensured a 98% nitrification efficiency (I stage). For denitrification (II stage), alternative carbon sources (ACS) (molasses, crude glycerine, or distillery stillage) were used. Two volumetric exchange rates (n) were tested: 0.35 1/d (COD/N-NO3 ratio of 8) and 0.5 1/d (COD/N-NO3 of 7). With all ACS and COD/N-NO3 ratios, almost 100% of nitrate was denitrified; at the COD/N-NO3 of 8, biodegradable organics remained in the effluents. At the COD/N-NO3 of 7, the denitrification removal rates were lower (29.6-45.1 mg N-NOx/(L center dot h)) than at the ratio of 8 (72.1-159.5 mg N-NOx/(L center dot h)), because of temporal nitrite accumulation. The highest nitrate removal rates were obtained with molasses, the lowest with a distillery stillage. Considering the nitrate removal rate and the effluent COD concentration, molasses was recommended as the most effective carbon source for AD effluent treatment at the COD/N-NO3 of 7.