Experimental Study On Bending Properties Of Cross-Laminated Timber-Bamboo Composites

Using bamboo and timber to manufacture cross-laminated timber-bamboo (CLTB) composites could utilize the advantages of two material to improve the mechanical properties and expand the raw material source of crosslaminated timber (CLT). To explore the feasibility of using engineered bamboo as CLT lamination, the rolling shear properties of two bamboo scrimbers and one bamboo plywood were evaluated. Two types of CLTB specimens, using bamboo scrimber as transverse layer or as both transverse layer and the outermost longitudinal layer, were developed in this study. The bending properties of CLTB and generic Spruce-pine-fir (SPF) CLT specimens were evaluated by dynamic tests and third-point bending tests, respectively. The shear analogy method was employed to calculate the apparent bending stiffness of CLT/CLTB specimen. The results indicated that the rolling shear modulus and strength of bamboo scrimber (group RB(F)-4.5) were 92.81% and 98.64% higher than those of bamboo plywood, respectively, and were 330.19% and 121.13% higher than those of SPF dimension lumber, respectively. The CLTB specimens, group BWBWB, had 23.69% and 60.50% higher apparent bending modulus and peak load than those of generic SPF CLT specimens. Most of the CLTB bending specimens had main failure mode of tensile failure in the bottom layer which replaced rolling shear failure in transverse bamboo scrimber layer. The apparent bending stiffness values of CLT/CLTB specimens obtained from dynamic test and shear analogy method were in good agreement with the static experimental values. The results presented in this paper can provide fundamental basis for supporting the potential engineering application of CLT panel products fabricated with bamboo scrimber.