2-D And 3-D Measurements Of Flame Stretch And Turbulence-Flame Interactions In Turbulent Premixed Flames Using Dns

Three-dimensional (3-D) measurements of flame stretch are experimentally challenging. In this paper, two-dimensional (2-D) and 3-D measurements of flame stretch and turbulence-flame interactions were examined using direct numerical simulation (DNS) data of turbulent premixed flames, and models to estimate 3-D statistics of flame stretch-related quantities by correcting 2-D measurements were developed. A variety of DNS cases were simulated, including three freely propagating planar flames without a mean shear and a slot-jet flame with a mean shear. The main findings are summarized as follows. First, the mean shear mainly influences the flame orientations. However, it does not change the flame stretch and turbulence-flame interactions qualitatively. The distributions of out-of-plane angle of all cases are nearly isotropic. Second, models were proposed to approximate the 3-D statistics of flame stretch-related quantities using 2-D measurements, the performance of which was verified by comparing modelled and actual 3-D surface averages and probability density functions of tangential strain rate, curvature and displacement velocity. Third, 2-D measurements of flame stretch capture properly the trends of the 3-D results, with flame surface area being produced in low curvature regions and destroyed in highly curved regions. However, the magnitude of flame stretch was under-estimated in 2-D measurements. Finally, 2-D and 3-D turbulence-flame interactions were examined. The flame normal vector is aligned with the most compressive strain rate in both 2-D and 3-D measurements. Meanwhile, the flame normal vector is misaligned (weakly aligned) with the most extensive strain rate in 3-D (2-D) measurements, highlighting the difference in 2-D and 3-D results of turbulence-flame interactions.