Experimental Investigation On The Dpf High-Temperature Filtration Performance Under Different Particle Loadings And Particle Deposition Distributions

Based on DPF filtration and regeneration bench, the solid particle emission and high-temperature filtration characteristics of different carbon black particle loadings and particle deposition distributions are studied. The aerosol generator (PAlAS RGB 1000) is used to introduce carbon black particles into the inlet of a DPF, and the NanoMet3 particle meter is used to measure the solid particle concentration at the inlet and outlet of a DPF to obtain the filtration characteristics. Previous studies found that without inlet carbon black particles, there was an obvious solid particle emission peak at the outlet of the deposited DPF during the heating, and the concentration increased by 1-2 orders of magnitude. In this paper, the high-temperature filtration characteristics under steady-state temperature conditions are studied. It is found that a DPF can reduce the range of inlet fluctuating particles, and with the increase of temperature, the proportion of large solid particles in the outlet particles increases, and the size distribution range decreases. Particle loading has positive and negative effects on the DPF filtration, and the DPF has the optimal particle loading, which makes the comprehensive filtration efficiency improve the highest. The deposition transition section can make the deposition particles in the DPF uniform, but the filtration efficiency is reduced.