Influence of Source Energy and Stacking on Active MASW Method Dispersion Image

The study investigates the influence of source weight, type of source plate and number of stacking on the resolution of the dispersion image obtained from the active Multichannel Analysis of Surface Waves (MASW) method at peat soil condition. Fundamental-mode dispersion curve determination is governed by the optimum configuration of the active MASW method. Optimum configuration will ensure reliable inverted shear wave velocity profile. The heterogeneity and problematic characteristics of peat soil provide challenges on the MASW survey. Based on the field tests conducted, the effect of the source weight was significant. Heavier source weight relatively increases the dispersion image resolution especially at lower frequencies but sacrificing the resolution at higher frequencies. Therefore, heavier source weight (i.e. 7 kg sledgehammer) was recommended for deeper depth of investigation with little concern on the shallow depth. The use of rubber plate also contributed to the increases of energy accumulation at lower frequencies. Increasing number of stacking increases the overall energy band as the stacking allows significant suppression of the ambient noise. 5 to 10 stacks were recommended for peat soil condition. Finally, overall comparison between the dispersion images obtained at both locations shows that thicker peat soil layer results in lower resolution and low signal-to-noise ratio dispersion image.