Effect Of Evaporated Gas Flow On Porosity And Microstructure Of In718 Parts Produced By Lpbf-Processes

Laser Powder Bed Fusion (LPBF) is the most widely used metal additive manufacturing (AM) process. A laser beam melts metal powder and partly the underlying solid metal to add metal layer by layer in selected regions. Temperatures up to the boiling temperature are reached resulting in a violent gas stream which affects solidification and can lead to porosity. Due to the small size of the melting zone, a detailed experimental analysis of the process is very difficult and simulation is an important tool to understand the manufacturing process and the influence of process parameter on the quality of components. In this work a three-phase melting and solidification simulation methodology has been used to investigate the melting, evaporation and solidification in a LPBF process. The methodology, originally developed to model casting processes, was extended by a model to calculate the heating of the metal powder by the laser beam and a metal evaporation model to include the effect of the evaporated metal gas on the total gas flow. The methodology was applied to analyse the melting, evaporation and solidification of single track experiments with IN718 powder. The simulation results were validated by comparing the calculated melt pool depth with the experimental findings. High laser power combined with slow laser speed leads to high energy densities at the melt pool, which result in a deep keyhole and increased porosity. The simulations revealed that evaporation of melt leads to a violent gas flow with velocities up to 100 m/s.