How to Reduce the Exposure of Welders to an Acceptable Level: Results of the InterWeld Study

Objectives Workplace measurements in the past have shown that the applicable occupational exposure limits (OELs) are regularly exceeded in practice when high-emission welding processes are applied. The InterWeld pilot study was planned as part of an intervention study to show under which conditions compliance with the OEL is achievable in gas metal arc welding (GMAW) with solid wire. The investigation focussed on local exhaust ventilation, i.e. captor hoods and welding torches with integrated fume extraction. Methods Forty tests with hand-guided GMAW were configured by experts with regard to all technical parameters and carried out by a professional welder. Effects of protective measures and process parameters on the exposure to respirable welding fumes and airborne manganese (Mn), chromium, nickel, and hexavalent chromium were investigated. Personal sampling was carried out in the welder's breathing zone outside the face shield at high flow rates (10 l min(-1)) in order to achieve sufficient filter loading. Particle masses and welding fume concentrations were determined by weighing the sampling filters. Metal concentrations were analysed by inductive coupled plasma mass spectrometry. In order to evaluate the effects on exposure, the measurements were performed under similar conditions. The data were analysed descriptively and with mixed linear models. For measurements below the limit of detection, the exposure level was estimated using multiple imputation. Results Two to five times higher exposures to respirable welding fumes and airborne metals were observed during welding of 10 mm sheets than during welding of 2- or 3-mm sheets. Welding fume and Mn exposure were reduced by 70 and 90% when on-torch extraction or a captor hood was applied. Other airborne metals were reduced to a similar extent. Modifications on welding parameters led to a reduction of exposure against respirable particles by 51 up to 54%. Conclusions Although proper extraction at the point of origin and lower-emitting process variants ensure a drastic reduction in exposure, compliance with current OELs is not guaranteed. In order to ensure adequate health protection, especially at workplaces where thick sheets with long relative arc times are processed, there is a need for technical development.