Effect of Lipidic Excipients on the Particle Properties and Aerosol Performance of High Drug Load Spray Dried Particles for Inhalation.

High drug load inhalable particles were prepared by co-spray drying a hydrophobic, crystalline, small molecule drug with various lipid or phospholipid excipients at a 9:1 molar ratio to understand the primary drivers of aerosol performance. The effect of excipient structure on solid-state, surface characteristics, and aerodynamic performance of the co-spray dried particles was studied while keeping the spray drying parameters constant. Spray drying of the drug with lipids produced crystalline drug particles, whereas phospholipids produced partially amorphous drug particles. All of the co-spray dried particles were nearly spherical with a smooth surface, except for the spray dried drug particles without excipients - which showed the presence of rough crystals on the surface. All co-spray dried particles showed surface enrichment of the excipient. The surface enrichment of the phospholipids was higher compared to the lipids. Co-spray dried particles that showed higher surface enrichment of excipients showed improved aerosol performance. In comparing all the excipients studied, distearyolphosphatidylcholine (DSPC) showed maximum enrichment on the particle surface and thereby significantly improved aerosol performance. This study demonstrated that the addition of small amounts of lipid excipients during spray drying can change surface morphology, composition, and cohesion, impacting aerosol performance of drugs.