Brazilian Tensile Failure Characteristics of Marine Shale under the Hydration Effect of Different Fluids

In this paper, shale gas cores from the Lower Silurian Longmaxi Formation in the Zhaotong National Shale Gas Demonstration Area were selected to study the hydration effect of different fluids on the fracture morphology inside the shale, the rock tensile strength and the Brazilian tensile failure mode. Fresh water and slick water were adopted for hydration pretreatments and the CT technique was used to compare the changes of the fabric in the shale. Then, Brazilian tensile tests were carried out to study the tensile strength and tensile failure modes of the shale specimen after hydration pretreatment. Finally, two horizontal wells in the study area were selected to perform pilot tests of hydration pretreatment in their fracturing operation sites. And the following research results were obtained. First, in the process of spontaneous imbibition, the hydration effect of fresh water is superior to that of slick water in promoting the fracture complexity of marine shale in the same hydration duration. Second, fresh water has greater surface tension and lower viscosity and its hydration effect can not only promote the propagation of original fractures but induce new micro-fractures or branches, while the hydration effect of slick water mainly promotes the propagation of original fractures. Third, due to hydration effect, marine shale is damaged and its tensile strength is reduced. After the hydration pretreatment by fresh water and slick water, the tensile strength of the shale specimens are reduced by 35.6% and 18.1%, respectively. Fourth, according to the propagation paths of main fractures, the Brazilian tensile failure modes of hydrated shale can be divided into four types (i.e., step shaped, dog-leg shaped, branching shaped and arc shaped) or their combinations, while the tensile failure mode of unhydrated shale is only a straight line. Fifth, hydration effect can effectively increase the complexity of the hydraulic fractures in marine shale, so if the conditions permit, it is recommended to inject a certain amount of fresh water at a high pumping rate within the limited pressure after perforation and to shut in the well until the hydraulic fracturing operation. And in order to reduce the difficulties of pumping the proppant during the hydraulic fracturing operation, a pumping strategy of “low proppant concentration, large volume of slurries” can be adopted to reach the expected proppant volume.