2d Photogrammetry As A Forwarder Load Measurement Technique

Research Highlights:In this study, we present the use of time-lapse photos as a way to estimate the height of the load on the forwarders. This approach, using nonprofessional outdoor cameras, is a cheap and time-effective solution for continuous load height measurements, and it offers at least the same accuracy as a gauge measurement. This method represents another approach to the automation of time studies in forestry.Background and Objectives:Time studies require information about the load on the forwarders. Until now, this information was obtained either by using a gauge measure, sampling of the load, or averaging the load from large area datasets. More accurate methods like laser scanning are costly and fragile. During time study preparations, we suggested a robust system of measuring the load height and tested it against the commonly used gauge measuring technique.Materials and Methods:Two cameras took pictures of the load; these photos were processed for camera lens distortion and rectified into the cartesian coordinate system, and the height of the load was calculated. These values were then tested against gauge measured values using pairedt-test.Results:Straight line distance calculated from the images and the gauge-measured distance did not show a significant difference (p-value 0.9354). Calculated vertical distance was, however, significantly different from the calculated straight-line distance (p-value of 0.0015), suggesting possible bias of the gauge measured distance. The root mean square error (RMSE) of the rectification process was, on average, 0.42 cm.Conclusions:The proposed method was verified to correspond with the gauge measure method; however, our research raised the question of the gauge method reliability, as the taken measurements are not perfectly vertical, and for the correct load estimation, the vertical distance is needed. We, therefore, conclude that for this photogrammetry method, the vertical, rather than straight-line, distance should be used. The presented solution can be used for long-term data collection without interrupting the whole forwarding process for taking the load measurement. The longer data processing in office enables researchers to spend less time in the field taking hand measurements.