EPJ Photovoltaics O pen A ccess 2 D modelling of polycrystalline silicon thin film solar cells

The influence of grain boundary (GB) properties on device parameters of polycrystalline silicon (poly-Si) thin film solar cells is investigated by two-dimensional device simulation. A realistic poly-Si thin film model cell composed of antireflection layer, (n)-type emitter, 1.5 μm thick p-type absorber, and (p)-type back surface field was created. The absorber consists of a low-defect crystalline Si grain with an adjacent highly defective grain boundary layer. The performances of a reference cell without GB, one with n-type and one with p-type GB, respectively, are compared. The doping concentration and defect density at the GB are varied. It is shown that the impact of the grain boundary on the poly-Si cell is twofold: a local potential barrier is created at the GB, and a part of the photogenerated current flows within the GB. Regarding the cell performance, a highly doped n-type GB is less critical in terms of the cell’s short circuit current than a highly doped p-type GB, but more detrimental in terms of the cell’s open circuit voltage and fill factor.