Biomechanical evaluation of autologous bone-cage in posterior lumbar interbody fusion: a finite element analysis

Background An autologous bone-cage made from the spinous process and laminae might provide a stability in posterior lumbar interbody fusion (PLIF) close that of the traditional-cage made of polyetheretherketone (PEEK) or titanium. The biomechanical effect of autologous bone-cages on cage stability, stress, and strains, and on the facet contact force has not been fully described. This study aimed to verify whether autologous bone-cages can achieve similar performance as that of PEEK cages in PLIF by using a finite element analysis. Methods The finite element models of PLIF with an autologous bone-cage, a titanium cage, and a PEEK cage were constructed. The autologous bone-cage was compared with the titanium and PEEK cages. The mechanical properties of the autologous bone-cage were obtained through mechanical tests. The four motion modes were simulated. The range of motion (ROM), the stress in the cage-end plate interface, and the facet joint force (FJF) were compared. Results The ROM was increased at adjacent levels but decreased over 97% at the treated levels, and the intradiscal pressure at adjacent levels was increased under all conditions in all models. The FJF disappeared at treated levels and increased under extension, lateral bending, and lateral rotation in all models. The maximum stress of the cage-endplate interface was much lower in the autologous bone-cage model than those in the PEEK and titanium cage models. Conclusions In a finite model of PLIF, the autologous bone-cage model could achieve stability close that of traditional titanium or PEEK cages, reducing the risk of subsidence.