Role of lipopolysaccharides and lipoteichoic acids on C-Chrysophsin-1 interactions with model Gram-positive and Gram-negative bacterial membranes.

Antimicrobial peptides (AMPs) are attractive as biomaterial coatings because they have broad spectrum activity against different microbes, with a low likelihood of incurring antimicrobial resistance. Direct action against the bacterial membrane is the most common mechanism of action (MOA) of AMPs, with specific MOAs dependent on membrane composition, peptide concentration, and environmental factors that include temperature. Chrysophsin-1 (CHY1) is a broad spectrum salt-tolerant AMP that is derived from a marine fish. A cysteine modification was made to the peptide to facilitate attachment to a surface, such as a biomedical device. The authors used quartz crystal microbalance with dissipation monitoring to study how temperature (23 and 37 degrees C) and lipid composition influence the MOA of cysteine-modified peptide (C-CHY1) with model membranes comprised of supported lipid bilayers (SLBs). These two temperatures were used so that the authors could better understand the differences in behavior between typical lab temperatures and physiologic conditions. The authors created model membranes that mimicked properties of Gram-negative and Gram-positive bacteria in order to understand how the mechanisms might differ for different types of bacterial systems. SLB models of Gram-positive bacterial membranes were formed using combinations of phosphatidylcholine, phosphatidylglycerol (PG), and S. aureus-derived lipoteichoic acid (LTA). SLB models of Gram-negative bacterial membranes were formed using combinations of phosphatidylethanolamine (PE), PG, and E. coli-derived lipopolysaccharides (LPS). The molecules that distinguish Gram-positive and Gram-negative membranes (LTA and LPS) have the potential to alter the MOA of C-CHY1 with the SLBs. The authors' results showed that the MOA for the Gram-positive SLBs was not sensitive to temperature, but the LTA addition did have an effect. Specifically, similar trends in frequency and dissipation changes across all overtones were observed, and the same mechanistic trends were observed in the polar plots at 23 and 37 degrees C. However, when LTA was added, polar plots showed an association between C-CHY1 and LTA, leading to SLB saturation. This was demonstrated by significant changes in dissipation, while the frequency (mass) was not increasing after the saturation point. For the Gram-negative SLBs, the composition did not have a significant effect on MOA, but the authors saw more differences between the two temperatures studied. The authors believe this is due to the fact that the gel-liquid crystal transition temperature of PE is 25 degrees C, which means that the bilayer is more rigid at 23 degrees C, compared to temperatures above the transition point. At 23 degrees C, a significant energetic shift would be required to allow for additional AMP insertion. This could be seen in the polar plots, where there was a steep slope but there was very little mass addition. At 37 degrees C, the membrane is more fluid and there is less of an energetic requirement for insertion. Therefore, the authors observed greater mass addition and fewer changes in dissipation. A better understanding of C-CHY1 MOA using different SLB models will allow for the more rational design of future therapeutic solutions that make use of antimicrobial peptides, including those involving biomaterial coatings.