Electron beam injection from a hollow cathode plasma into a downstream reactive environment: Characterization of secondary plasma production and Si3N4 and Si etching

A material etching system was developed by combining beam electron injection from a direct current hollow cathode (HC) electron source with the downstream reactive environment of a remote CF4/O-2 low temperature plasma. The energy of the injected beam electrons is controlled using an acceleration electrode biased positively relative to the HC argon discharge. For an acceleration voltage greater than the ionization potential of Ar, the extracted primary electrons can produce a secondary plasma in the process chamber. The authors characterized the properties of the secondary plasma by performing Langmuir probe measurements of the electron energy probability function (EEPF) 2.5cm below the extraction ring. The data indicate the existence of two major groups of electrons, including electrons with a primary beam electron energy that varies as the acceleration voltage is varied along with low energy electrons produced by ionization of the Ar gas atoms in the process chamber by the injected beam electrons. When combining the HC Ar beam electron with a remote CF4/O-2 electron cyclotron wave resonance plasma, the EEPF of both the low energy plasma electron and beam electron components decreases. Additionally, the authors studied surface etching of Si3N4 and polycrystalline Si (poly-Si) thin films as a function of process parameters, including the acceleration voltage (0-70V), discharge current of the HC discharge (1-2A), pressure (2-100mTorr), source to substrate distance (2.5-5cm), and feed gas composition (with or without CF4/O-2). The direction of the incident beam electrons was perpendicular to the surface. Si3N4 and polycrystalline silicon etching are seen and indicate an electron-neutral synergy effect. Little to no remote plasma spontaneous etching was observed for the conditions used in this study, and the etching is confined to the substrate area irradiated by the injected beam electrons. The electron etched Si3N4 surface etching rate profile distribution is confined within a similar to 30mm diameter circle, which is slightly broader than the area for which poly-Si etching is seen, and coincides closely with the spatial profile of beam electrons as determined by the Langmuir probe measurements. The magnitude of the poly-Si etching rate is by a factor of two times smaller than the Si3N4 etching rate. The authors discuss possible explanations of the data and the role of surface charging. Published under license by AIP Publishing.