Effect of weld parameters on mechanical properties and tensile behavior of tungsten inert gas welded AW6082-T6 aluminium alloy

The effect of different welding parameters on the mechanical properties and tensile behavior of tungsten inert gas (TIG) welded joints was analyzed. Four different groove angles were chosen, 60°, 70°, 80° and 90°, to ascertain the tendency of microstructure formation and quality of the weld. Mechanical properties were assessed in the terms of Vickers HV1 hardness. Microanalysis of test samples produced using different current 165 A, 180 A, 200 A with same groove angle of 90° was done in fusion, partially melted, and heat affected zone; all the images showed good penetration and clear transition from one to following zone. The transverse tensile tests were accomplished on the welded joints to evaluate influence of welding parameters and groove geometry to the joint tensile strength and its behavior during exploitation. It was verified that the tensile strength of the welds is closely related to the welding parameters. The chosen 180 A welding current ensured highest tensile strength of test samples; the same as proper selection of groove angle (90°) provides good fusion and high quality of major welds. The results revealed that the weld penetration depends on welding current.