Analysis Of Temperature Field, Heat And Fluid Flow Of Two-Phase Zone Continuous Casting Cu-Sn Alloy Wire

Cu-4.7 wt. % Sn alloy wire with O10 mm was prepared by two-phase zone continuous casting technology, and the temperature field, heat and fluid flow were investigated by the numerical simulated method. As the melting temperature, mold temperature, continuous casting speed and cooling water temperature is 1200 degrees C, 1040 degrees C, 20 mm/min and 18 degrees C, respectively, the alloy temperature in the mold is in the range of 720 degrees C-1081 degrees C, and the solid/liquid interface is in the mold. In the center of the mold, the heat flow direction is vertically downward. At the upper wall of the mold, the heat flow direction is obliquely downward and deflects toward the mold, and at the lower wall of the mold, the heat flow deflects toward the alloy. There is a complex circular flow in the mold. Liquid alloy flows downward along the wall of the mold and flows upward in the center.