A randomised controlled study on the effects of different surface treatments and adhesive self-etch functional monomers on the immediate repair bond strength and integrity of the repaired resin composite interface

Objectives To evaluate the effects of different surface conditioning methods on the immediate repair bond strength and integrity of the repaired composite interface. Methods One hundred and five resin composite blocks made of a nanohybrid resin composite were randomly assigned to one of the following surface conditioning groups (n = 15/group): Group 1: Gluma Self Etch™ adhesive system, Group 2: Tokuyama Bond Force II™ adhesive system, Group 3: non-roughened and non-conditioned surfaces, Group 4: sandblasting and Gluma Self Etch™, Group 5: sandblasting and Tokuyama Bond Force II™, Group 6: sandblasting only. A positive control group was also used.Resin composite identical to the substrate was applied and the repaired specimens were subjected to shear bond strength (SBS) testing. Representative samples from all groups were subjected to scanning electron microscopy and surface profilometry to determine their mode of failure. The data were analysed statistically using Analysis of Variance (ANOVA) and two independent sample t-test (α = 0.05). Results The mean SBS of all test groups ranged between 1.92 and 5.40 MPa and varied with the degree of composite surface roughness and the type of adhesive system employed. Significantly highest SBS values (5.40 ± 0.36 MPa) were obtained in Group 5 (p = 0.017) which were comparable to the coherent strength of the resin composite in the positive control group (p > 0.05). Conclusions Under the tested conditions, significantly greater SBS of repaired resin composite was achieved when the substrate surface was conditioned by sandblasting followed by the application of the Tokuyama Bond Force II™ adhesive system. Clinical significance Effecting a repair of a nanohybrid composite restoration with sandblasting and the application of TBF II would seem to enhance the interfacial bond strength and integrity of the repaired resin composite interface. Clinical trials are necessary to determine the usefulness of this technique.