Influences of the chain structure of PE-b-PEG on the properties of PE/PE-b-PEG blend membranes prepared by TIPS: Research Article

In this article, a series of diblock copolymer polyethylene-b- poly(ethylene glycol)s (PE-b-PEGs) with various molecular weight of polyethylene segment was blended with linear low-density PE. The PE/PE-b-PEG blend porous membranes with high porosity were obtained by thermally induced phase separation (TIPS) process. The isothermal crystallization kinetics of PE/LP/PE-b-PEG blends indicated that the introduction of PE-b-PEG could inhibit the growth rate of polyethylene crystals which could increase the pore size and porosity of the membranes. The PE/PE-b-PEG blend membranes with PE1300-b-PEG(2200) showed the largest pore size and porosity due to its crystallization behavior during TIPS. The surface of the membranes became smoother and the morphology of the membranes could be effectively tuned by introducing PE-b-PEG. Compared with the PE membrane, the PE/PE-b-PEG blend membranes exhibited higher hydrophilicity (the water contact angle decreased from 112 degrees to 84 degrees), water permeability (the permeation flux increased from 80 to 440 L/m(2) h under 0.1 MPa), rejection performance (completely reject carbon particles in the filtration of carbon ink solution), and fouling resistance (the value of protein adsorption dropped from 0.25 to 0.05 mg/cm(2)). The hydrophilicity and fouling resistance of PE/PE-b-PEG blend membranes increased as the length of PE segment in PE-b-PEGs decreased. (c) 2018 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2018, 135, 46499.