Efficacy of three disinfectants against Senecavirus A on five surfaces and at two temperatures

Objectives: To evaluate the virucidal efficacy of three commercial disinfectants against Senecavirus A (SVA) on five different surfaces at similar to 25 degrees C and 4 degrees C. Materials and methods: Household bleach, a phenolic disinfectant, and a quaternary ammonium-aldehyde disinfectant were tested at manufacturers recommended concentrations against a contemporary strain of SVA on aluminum, stainless steel, rubber, cement, and plastic surfaces at similar to 25 degrees C and 4 degrees C. Virus propagation and titration were performed on swine testicular cells. Viral titers were calculated before and after exposure to the disinfectant being tested. Results: At similar to 25 degrees C, household bleach at 1:20 dilution inactivated >= 99.99% of the virus within 10 to 15 minutes on aluminum, rubber, and plastic. On stainless steel and cured cement, it inactivated 99.97% and 99.98% of the virus, respectively. At 4 degrees C, bleach inactivated >= 99.99% of the virus within 5 to15 minutes on all surfaces except rubber; on rubber, inactivation was 99.91% after 15 minutes. The phenolic disinfectant at the manufacturers recommended concentration inactivated only <= 82.41% of the virus at either temperature and on any surface, even after a 60-minute contact time. Results for the quaternary ammonium disinfectant were intermediate: 78.12% to 99.81% of the virus was inactivated within 60 minutes at both temperatures and on all surfaces. To detect differences between disinfectants, paired Wilcoxon tests were performed. At 10- and 15-minute time points, efficacies of the three disinfectants differed significantly.