Effects of thermal pretreatment and catalyst on biomass gasification efficiency and syngas composition

GREEN CHEMISTRY(2016)

引用 64|浏览13
暂无评分
摘要
This work explores the combined effects of thermal pretreatment and using a catalyst in situ on gasification carbon conversion efficiency, as well as product gas and tar content and compositions. To compare the effects of thermal pretreatment, pelletized and ground oak with three different levels of thermal pretreatment were gasified in a fluidized bed reactor. The pretreatments applied to the oak were (1) pelletization, (2) drying at 180 degrees C in air, and (3) torrefaction at 270 degrees C in nitrogen. The oak dried at 180 degrees C produced syngas of similar quality and approximately the same amount of char as untreated oak. Torrefaction at 270 degrees C resulted in syngas with a higher hydrogen to CO ratio, lower methane, and less than half of the total tar-all of which are desirable properties in terms of product gas quality. However, the oak torrefied at 270 degrees C also produced more than two times the amount of char as the untreated, pelletized oak. To determine the effect of catalyst, a series of experiments were conducted using olivine impregnated with nickel and cerium as the fluidized bed material in the gasifier. These tests showed that modified olivine can improve hydrogen production and reduce methane and tar levels in the syngas. The result was observed for both treated and untreated oak; although the effect was more substantial for untreated oak, for which the use of modified olivine reduced tar concentrations in the product gas by 60%, with a larger reduction in heavier tars than lighter tars. This result is important because reduction in heavier tar plays a more important role in benefitting downstream operations.
更多
查看译文
关键词
biomass gasification efficiency,syngas composition,thermal pretreatment,catalyst
AI 理解论文
溯源树
样例
生成溯源树,研究论文发展脉络
Chat Paper
正在生成论文摘要