Reflex Triode Vircator Design For Extended Frequency Tuning Capabilities

A stand-alone vircator based high power microwave system has been designed as an effects test source [1-2]. The goal of this system is to cover the frequencies from 4.0 GHz to 6.0 GHz. To date a working prototype has been manufactured and field tested. The current system is capable of producing microwaves at frequencies of 4.06, 4.27, 4.45, 5.83, 5.95 and 6.06 GHz at field levels in excess of 100 kV/m, measured at 3 meters. Additionally, the source and all subsystems are capable of burst mode operation for a duration of 2 s at 500 Hz pulse repetition frequency (PRF). The wide range of tunability was achieved by varying the A-K gap as well as the location of the A-K gap inside the cavity. The A-K gap is varied by a bellows sealed linear actuator which is attached to the cathode. The position of the A-K gap within the cavity is altered by moving a liner and microwave reflector (which form a cavity) within the main vacuum tube. However, the experimentally observed frequencies obtained with the current system leaves a gap from 4.45 to 5.6 GHz. In order for the test system to produce microwaves within this frequency range, a new tube is under development. The cavity of the new tube has a smaller cavity which should push the resonant frequencies into the desired range (from 4.45 GHz to 5.6 GHz). This presentation discusses the experimental results obtained with the new tube and compares that with the previously built and tested source.