Modified Mesoporous Silica For Efficient Siloxane Capture

In this study, octamethylcyclotetrasiloxane (D4) was removed by using a novel modified solid adsorbent of mesoporous silica. The adsorbent was synthesized using inverse micelles with some modifications in the synthesis process (temperature of gelation) and in the post treatment conditions (calcination temperature and heating rate) with a concomitant improvement of D4 uptake. This is the first report on regulating the textural properties of the mesoporous silica material UCT-14 to develop an active silica adsorbent. These adjustments resulted in an increase of the silica surface area from 391 to 798 m(2).g(-1), which leads to a high capacity (686 mg.g(-1)) of D4-capture for the silica synthesized at 80 degrees C, calcined at 450 degrees C with the heating rate of 100 degrees C min1 (Si-Syn80). This adsorbent showed comparable adsorption performance with the widely used commercial silica gel under dry and humid condition. Recyclability tests on the commercial silica gel and mesoporous silica synthesized at 120 degrees C and calcined at 450 degrees C with a heating rate of 100 degrees C.min(-1) (called Si-Syn120 or Si-450 or Si-100 degrees C.min(-1)) indicated that the Si-Syn120 (capacity drop 10%) is more efficient than silica gel (capacity drop 15%) after three cycles. Although, the presence of moisture (25%) in the nitrogen gas stream led to capacity reduction in both Si-Syn120 and commercial silica gel, the modified UCT-14 shows slightly better resistance to humid condition.