Mission Design and GNC for In-Orbit Demonstration of Active Debris Removal Technologies with CubeSats
Acta Astronautica(2017)
Abstract
Within the frame of the ESA's General Support Technology Programme, two In-Orbit Demonstration (IOD) missions using CubeSat technologies were studied. These IODs aim at alleviating the technical risk inherent to new technologies required for Active Debris Removal (ADR) of large space objects, by using small and low-cost CubeSat systems. Rendezvous and docking with uncooperative debris has been only partially demonstrated and still raises technological issues. To test technologies such as the navigation and Rendezvous (RV) sensors or capture systems, our studies show that CubeSat missions are appropriate. Already, Guidance, Navigation and Control (GNC), communications and power technologies have successfully been miniaturised and the corresponding equipments are now available to the CubeSat community. This fact extends the range of feasible CubeSat missions from the initial flight of simple sensors to more complex systems. This paper presents two CubeSat ADR experiments and demonstrates how mission design and GNC can serve the verification of navigation sensors performances as well as the validation of uncooperative debris capture using a net. Each mission is composed of a Chaser and a Target. The former being an 8 Units (8U) CubeSat and the latter a 4U, launched together in a 12U deployer. Both satellites are 3-axis attitude controlled. The Chaser has in addition 3 Degrees of Freedom (DoF) translation capability using 1mN cold gas thrusters. Both CubeSats will carry GNSS receivers to assist in the determination of range and relative velocity. The global positioning and attitude data of the Target will be transmitted to the Chaser using an inter-satellite link having the additional capacity to measure the corresponding range. This system provides a reference validation for the RV sensors. The relative position and velocity to be controlled are fully observable. Thus a linear quadratic regulator is appropriate to ensure robust and optimal control. Based on the mission design, various close inspection configurations are demonstrated. To emphasise the feasibility of such missions, a system approach will be briefly addressed. Both missions are analysed using a 6 DoF simulator. The performances and absolute errors of the GNC as well as fuel consumption are provided. Power consumption, Telecom capability and thermal aspects will be shown for sake of completeness. Current issues and limitations of the CubeSat GNC will be discussed, as well as conclusions regarding the feasibility of such missions.
MoreTranslated text
Key words
active debris removal technologies,in-orbit
AI Read Science
Must-Reading Tree
Example
![](https://originalfileserver.aminer.cn/sys/aminer/pubs/mrt_preview.jpeg)
Generate MRT to find the research sequence of this paper
Chat Paper
Summary is being generated by the instructions you defined