The choice of dynamic amplification factors for the ITER generic port plugs during disruptions

The purpose of this paper is present an overview of the methodology followed to calculate the dynamic amplification factors applied to the electromagnetic loads acting in the ITER generic port plugs. The methodology used for combining an EM transient event with another kind of load is based in the treated of this dynamic EM event as a static load. As first stage a transient dynamic analysis was performed, at the most demanded electromagnetic event [2], to determine the dynamic response of the port plugs. In the same way, have been solved all the time steps of the dynamic event as static loads, it means that the inertial effect has been neglected. The response of each time-step at the dynamic solution has been compared with the same time-step solved as a static load. For this purpose some control points were positioned along the structure at the most representative locations. The key of these calculations is the understanding of the deformed modes affecting the port plug in order to obtain a reasonable dynamic amplification factors that permit the characterization of these loads in a realistic way and does not derive in a too conservative approach. Additionally, the fundamental frequencies and vibration modes of the generic port plug, requested for the characterization of the damping effects at the structure, were calculated in a complementary modal analysis performed for this aim. (C) 2015 Elsevier B.V. All rights reserved.