OSL properties of KMgF 3 :Tm 3+ for dosimetric applications as OSL dosimeter.

Luis Camargo, Lituania Pérez Cruz,Epifanio Cruz-Zaragoza, Segundo Martínez Ovalle,Julián Marcazzó

Applied Radiation and Isotopes(2018)

引用 10|浏览3
暂无评分
摘要
The optically stimulated luminescence (OSL) properties of undoped and Tm3+-doped KMgF3 fluoroperovskite have been investigated for the first time. KMgF3 compounds were synthesized by solid state reaction method and two different procedures were employed to improve the contact among the reagents, namely, the compressed powder was put either in an alumina crucible or in a platinum foil. The maximum OSL emission was found in samples prepared in an alumina crucible and doped with 0.5% mol of thulium. The radioluminescence (RL) spectrum shows two emission peaks at 455 and 360 nm, which can be ascribed to the 1D2–3F4 and 1D2–3H6 transitions of Tm3+ cations. The OSL dosimetric properties of the most promising composition, namely, KMgF3:Tm3+ (0.5% mol), have also been determined and analyzed. This compound exhibits good linearity in the dose range from 0.1 up to 100 Gy and satisfactory repeatability with a percentage standard deviation of 2.4%. Therefore, an OSL fading of approximately 75% in the first 36 h of storage is observed and then, the response remains almost constant. These characteristics, together with a minimum detectable dose of 0.04 Gy and the rapid erasing of the OSL signal after 100 s of stimulation, which makes feasible to bleach completely the residual OSL in order to restore the sample between dose measurements, suggest the potential of this perovskite as OSL dosimeter.
更多
查看译文
关键词
Optically stimulated luminescence,Fluoroperovskite,Dosimetry
AI 理解论文
溯源树
样例
生成溯源树,研究论文发展脉络
Chat Paper
正在生成论文摘要