Supersolidus liquid phase sintering of water-atomized low-alloy steel in binder jetting additive manufacturing

This work investigates the feasibility of net shape manufacturing of parts using water-atomized (WA) low-alloy steel with comparable densities to conventional powder metallurgy parts via binder jetting additive manufacturing (BJAM) and supersolidus liquid phase sintering (SLPS). In this study, a modified water-atomized powder grade with similar composition as MPIF FL-4405 was printed and pressure-less sintered under a 95% N2-5% H2 atmosphere. Combinations of two different sintering schedules (direct-sintering and step-sintering) and three different heating rates (1, 3, and 5 degrees C/min) were applied to study the densification, shrinkage, and microstructural evolution of BJAM parts. This study demonstrated that, although the green density of the BJAM samples was -42% of the theoretical density, the sintered parts experienced large linear shrinkage up to -25% and reached -97% density without compromising shape fidelity. This was ascribed to a more homogeneous pore distribution throughout the part before ramping up to the SLPS region. The synergistic effects of carbon residue, the slow heating rate, and the additional isothermal holding stage at the solid-phase sintering region were determined to be the key factors for sintering BJAM WA low-alloy steel powders with resulting minimal entrapped porosity and good shape fidelity.