Significance of minor alloying additions and impurities on alumina scale growth and adherence in FeCrAl alloys

Ultra-high purity Fe-Cr-Al-Y model alloys with controlled additions of impurities such as phosphorus and carbon, and potentially more beneficial elements such as titanium and zirconium have been prepared by induction melting in water-cooled, silver crucibles. 1 mm thick samples were then prepared by hot and cold rolling and annealing prior to cyclic oxidation in air at temperatures in the range 1100-1300degreesC. Other impurities were kept to a minimum of <10 ppm. scanning electron microscopy, Auger surface analysis and Scanning Transmission Electron Microscopy were used to characterise the samples both before and after oxidation. Weight gain studies during oxidation showed that the high phosphorus containing alloy went into breakaway very quickly, after only 200 hours at 1300degreesC, while the Ti and Zr rich samples lasted for 1900 hours and 3300 hours respectively. In some cases, chromium or titanium rich precipitates were found along the alloy grain boundaries, often associated with carbon, while in other cases precipitates were found along the oxide metal interface. Although phosphorus was found at this interface in some of the samples, it was not always present, and may not be the only contributing factor to the premature breakaway failure of the oxides. A complete review of the microstructural evolution of these samples during oxidation will form the main topic of this paper.