RELATIVE INFLUENCE OF TRANS-PACIFIC AND REGIONAL ATMOSPHERIC TRANSPORT OF PAHS IN THE PACIFIC NORTHWEST, USA

ENVIRONMENTAL SCIENCE & TECHNOLOGY(2015)

Cited 38|Views12
No score
Abstract
The relative influences of trans-Pacific and regional atmospheric transport on measured concentrations of polycyclic aromatic hydrocarbons (PAHs), PAR derivatives (nitro- (NPAH) and oxy-(OPAH)), organic carbon (OC), and particulate matter (PM) less than 2.5 mu m in diameter (PM2.5) were investigated in the Pacific Northwest, U.S. in 2010-2011. Ambient high volume PM2.5 air samples were collected at two sites in the Pacific Northwest: (1.) Mount Bachelor Observatory (MBO) in the Oregon Cascade Range (2763 m above sea level (asl)) and 2.) Confederated Tribes of the Umatilla Indian Reservation (CTUIR) in the Columbia River Gorge (CRG) (954 m asl). At MBO, the 1,8-dinitropyrene concentration was significantly positively correlated with the time a sampled air mass spent over Asia, suggesting that this NPAH may be a good marker for trans-Pacific atmospheric transport. At CTUIR, NOx, CO2, and SO2 emissions from a 585 MW coal fired power plant, in Boardman OR, were found to be significantly positively correlated with PAR, OPAH, NPAH, OC, and PM2.5 concentrations. By comparing the Boardman Plant operational time frames when the plant was operating to when it was shut down, the plant was found to contribute a large percentage of the measured PAR (67%), NPAH (91%), OPAH (54%), PM2.5 (39%), and OC (38%) concentrations at CTUIR and the CRG prior to Spring 2011 and likely masked trans-Pacific atmospheric transport events to the CRG. Upgrades installed to the Boardman Plant in the spring of 2011 dramatically reduced the plant's contribution to PAR and OPAH concentrations (by similar to 72% and similar to 40%, respectively) at CTUIR and the CRG, but not NPAH, PM2.5 or OC concentrations.
More
Translated text
Key words
pha,air pollution
AI Read Science
Must-Reading Tree
Example
Generate MRT to find the research sequence of this paper
Chat Paper
Summary is being generated by the instructions you defined