[Biomechanical study on the effect of the length of cervical anterior fusion on adjacent levels].

OBJECTIVE:To study the effect of length of cervical anterior fusion on adjacent levels by Biomechanical test. METHODS:Six fresh-frozen human cervical specimens were used in this study. The specimens were tested in flexion, extension, bending and rotation on a spine 3D test system. The specimens were tested intact and then underwent a single-level anterior cervical discectomy and fusion (ACDF) at the C4-5 first, a double-level fusion at the C4-6, and finally extended to triple-level at the C4-7, Based on a hybrid test method. Changes in overall range of motion (ROM), segmental motion and facet joints pressure during flexion, extension, bending and rotation were measured and statistically analyzed. RESULTS:The overall ROM of the entire spinal construct decreased progressively as the single-level fixation extending to 2-level and 3-level (P < 0.05). A progressive increase in ROM above (C3-4) the fused motion segment units (MSUs) was found during flexion, extension and bending (P < 0.05). In bending and extension, a same result was recorded on the average pressure and max pressure of C3-4 facet joints (P < 0.05). CONCLUSIONS:This study has demonstrated that the biomechanics at adjacent levels to a cervical spine fusion are altered and that there was progressively increased adjacent segment motion and stress as a single-level ACDF extended to a 3-level fusion, which might lead to the acceleration of adjacent segment degeneration.