The physical properties of silicone impression materials with hydrophilicity and hydrophobicity. Wetting, water absorption, surface structure of dental stone and dimensional change on stone dies]

In order to compare the physical properties of the silicone impression materials with regard to their hydrophilicity and hydrophobicity, wetting and water absorption, the surface structure and dimensional changes of stone dies were investigated. The evaluation of wetting was performed on one kind of addition-type material with hydrophilicity, five kinds of addition-type materials with hydrophobicity and one kind of condensation-type silicone impression material. One kind of addition-type silicone impression material with hydrophilicity and hydrophobicity was used in other research. Wetting was assessed by measuring the contact angle between water and the impression materials. Water absorption was assessed by the change in weight of the impression materials after immersion in water. The surface structure of the dental stone was observed by SEM. The dimensional changes of stone dies were measured by means of an apparatus designed in this department. The results were as follows: 1. Wetting: The addition-type impression material with hydrophilicity had a 51.4 +/- 1.3 degree contact angle, and other impression materials varied from 84.6 +/- 6.1 degrees to 97.7 +/- 4.4 degrees. 2. Water absorption: The amount of water absorption of the hydrophilic type was greater than that of the hydrophobic type. 3. The surface structure of dental stone: In the case of Vermix stone, which was poured into water-immersed hydrophilic type material, the stone crystals became large, but Fujirock showed no change. 4. The dimensional change on stone dies: No difference was apparent between the hydrophilic type and the hydrophobicity type. 5. Hydrophilicity may affect the surface structure of the dental stone slightly but this is possible within the permissible clinical limits.