Contact- and contact-free wear between various resin composites.

OBJECTIVE:Nowadays direct and indirect resin composites are frequently applied to build up the occlusion when extensive tooth wear took place. To achieve long-lasting restorations it is essential to obtain knowledge about their interactions due to occlusal contacts. Therefore, the two- and three-body wear between frequently used direct and indirect resin composites was investigated. MATERIALS AND METHODS:The two- and three-body wear of three direct resin composites and three indirect resin composites, with Clearfil AP-X, Filtek Z250, and Filtek Supreme XT as antagonists, were measured, using the ACTA wear device. The wear rates were determined and the surfaces were evaluated with SEM. RESULTS:The most remarkable outcome was that the two-body wear rate of the different composites opposing the Z250 wheel were significantly higher. Furthermore, it was shown that the three-body wear rate was independent on the antagonist and in general higher than the two-body wear rate. CONCLUSIONS:To reduce abrasion of the opposing resin composite surface the resin composite fillers should consist of a softer glass, e.g. barium glass or in case of a harder filler the size should be reduced to nano-size.