Characterization, Modelling, And Parameter Sensitivity Study On Electronic Packaging Polymers

Thermosetting polymers are widely used in electronic packaging. For instance, epoxy molding compound is extensively used as an encapsulant for electronic packages to protect the IC chips from mechanical and chemical hazards. It is well known that molding compounds show not only strong temperature dependent but also time dependent behavior. The thermo-mechanical behavior of these polymer constituents determines the performance, such as functionality and reliability, of the final products. In this paper, experimental characterization was carried out to investigate the time and temperature dependent properties of the selected molding compound. Thermal Mechanical Analysis (TMA) was applied to measure the CTE of the materials. Dynamical Mechanical Analysis (DMA) measurement was performed using temperature and frequency sweep modes. Finite element modeling was conducted on typical QFN (Quad Flat Non-lead) package device. Three material models, i.e., full viscoelastic model, temperature-dependent elastic model (1Hz DMA data) and constant elastic model, are used respectively to describe the behavior of the molding compound. The output responses of the simulations are von Mises stress distribution, package warpage and interlaminar stresses. The results show that the von Mises stress and package warpage are significantly different when considering the EMC as full viscoealstic, temperature-dependent elastic and constant elastic.