Investigation of the Experimental Factors Affecting the Trithiocarbonate-Mediated RAFT Polymerization of Methyl Acrylate

The reversible addition-fragmentation chain transfer polymerization of acrylates, using methyl acrylate (MA) as a monomer model, mediated by a trithiocarbonate was tested under several conditions where the experimental parameters were systematically altered. The most significant parameter in controlling the rate and control of the polymerization was found to be the ratio of chain transfer agent (CTA) to initiator. Decreasing this ratio increased the rate of polymerization and had little noticeable effect on the control over molecular weight distribution. A ratio of CTA to initiator of unity was shown to give the best compromise between rate and control of the polymerization. Targeted degrees of polymerization (equivalent to ratios of monomer to CTA) had negligible effect on the rate of polymerization and polydispersity index (PDI). Performing the polymerization in the presence of solvent (up to 41.2% (w/w) in toluene) had no negative effect on the rate of polymerization. Indeed, marginally higher conversions and lower PDIs than for bulk polymerization were achieved for similar reaction times. A higher amount of toluene (66.6% (w/w)) induced a lower rate of polymerization, but the evolution of molecular weight and PDI were unaffected. Polymerizations performed in the presence of toluene, N,N'-dimethylformamide, and methyl ethyl ketone showed that solvent polarity and aromaticity had no observable effect on the rate of polymerization and over the control of molecular weight distribution. The optimum conditions for the polymerization of MA, mediated by 2-ethylthiocarbonylsulfanyl-propionic acid ethyl ester at 50 degrees C were found to be [ CTA]/[ AIBN]= 1/1 and similar to 40% solvent (w/w).