An Optimization Procedure To Reconstruct The Automobile Ingress Movement
ICINCO 2008: PROCEEDINGS OF THE FIFTH INTERNATIONAL CONFERENCE ON INFORMATICS IN CONTROL, AUTOMATION AND ROBOTICS, VOL RA-2: ROBOTICS AND AUTOMATION, VOL 2(2008)
摘要
To simulate the automobile ingress movement, joint angles are needed. The joint angles are computed from the experimental data issued from an optoelectronic motion capture system. As these systems are often corrupted by problems related either to the system or to the experimentation, the computed angles are biased. Lempereur et al. (2003) proposed an optimization procedure to remedy to this problem. However, their method gives good results only on the end effectors' trajectories, while the other bodies' trajectories are not considered by their method. That degrades the positions of these parts and causes their eventual collisions with the vehicle's parts. On the other hand the corrected angles present some vibrations causing unrealistic simulation. In this paper we present a multi objective optimization based procedure to correct the joint articulation angles in automobile ingress movement. Our method minimizes the distance between all reconstructed trajectories with the real ones at each step of time. Our method follows a compromise between all trajectories of the model. Our method gives better global results. Correction of the joint angles allows a realistic simulation.
更多查看译文
关键词
multi objective optimization, modelling and simulation, automobile ingress movement reconstruction
AI 理解论文
溯源树
样例
生成溯源树,研究论文发展脉络