Pile instrumentation using retrievable sensors

Strain gauges are normally used to monitor the shortening or compression of pile during static pilt load test. For concrete spun pile, the technique used either by incorporating high temperature-resistant strain gauges into the heat-cured production process of the spun piles or by installing an instrumented steel pipe into the hollow core of the spun piles followed by cement grout infilling. The former is extremely unpopular due to high cost of these gauges and the uncertainty over their ability to survive the pile production and driving processes. The shortcoming of the other technique is the infilling of cement grout substantially alters the structural properties of the piles, thus rendering their load-response behaviour significantly different from that of the actual working piles. To address the difficulties of the above techniques a new method was recently developed by the authors, which uses retrieval sensors instead of strain gauges (which have to be sacrificed in every test). The method also has the ability to monitor loads and displacements at various levels along the pile shaft and toe of instrumented piles. Results of field tests show high quality, reliable and consistent data, clearly far exceeding the capability of both conventional and approximate methods of using strain gauges. © 2008 Science Publications.